How To Build Support Beams

Building support beams is one of the easier aspects of building a home. Although there are certain criteria that need to be met for support beams in relation to the load that is being supported, the actual building of the support beams is a task any handyman can complete.

Step 1

Measure the length where the support beam is needed. Consult a building chart to determine the proper dimensional lumber that is needed to cover the distance. Buy the dimensional lumber from a building supply house to build the beams.

Step 2

Set up the saw horses. Get the circular saw and extension cord set up. Place the sheet of plywood on the saw horses. Cut the plywood in 8-foot strips 1/4 inch narrower than the width of the appropriate lumber for the beams.

Step 3

Place the the appropriate dimensional lumber for the beams on the sawhorses. For each beam use the tape measure to measure the dimensional lumber the required length. Mark the length with a V pointing to the position of the saw line. Use the speed square to draw a straight line across the width of the lumber. Cut the lumber for the beams.

Step 4

Cut the 8-foot plywood strips 1/4 inch shorter than the two boards for the support beam. Place one of the boards for the beam flat on the saw horse. Place the plywood strip on the board for the beam. Lay the other board for the beam on top of the plywood. Remember to stagger the joints in the support beam so that they fall closely to where the support posts will be.

Step 5

Make sure that the ends and sides of the boards are flush The plywood should not protrude from within the center of the boards for the beam. Begin at one end of the beam and nail the boards together using the 12 penny nails and hammer. The nails should be driven into the wood in an alternating V pattern. Flip the beam over. Nail the boards from the other side using the same V shaped pattern. The beam is complete and ready for installation.